ContentsPreviousNext |
Using the Maintenance menu, you can specify machine maintenance settings for adjusting settings such as gradation and density.
Nozzle Check
You can print a test pattern to check whether the inks are being correctly ejected from the print head nozzles.
Head-cleaning
You can clean the print head.
Clean the head if certain colors are not printed or are printed faintly.
Head cleaning consumes ink.
Head-flushing
You can clean the print head more thoroughly.
Because head flushing consumes more ink than head cleaning, do it only if the print head cannot be cleaned properly by head cleaning.
If any print cartridge is empty, you cannot perform head-flushing.
Head Position
If bidirectionally printed lines are vertically misaligned, or if printed images are blurred, print the test pattern and adjust the print head alignment.
Adj.Paper Feed
If printed lines are horizontally misaligned or if images are printed unevenly, print the test pattern and adjust the paper feed setting.
Registration
Print the test pattern and align the point where printing starts for each paper feed tray.
Paper Feed Test
To remove moisture from inside the machine, you can eject a sheet of paper without printing anything on it.
De-condensation
To remove moisture from inside the machine, you can eject three sheets of paper without printing anything on them.
Move Prnt-Heads
If paper is jammed, you can move the print head to release the paper at the right side.
Reset Counter For details
Recycl.Ppr.Mode
Specify whether or not to print using [Recycl.Ppr.Mode]. Printing on paper that is dry and static attractive can cause problems such as nozzle clogging.
The [Recycl.Ppr.Model] function prevents such problems occurring when printing on this kind of paper or recycled paper.
On
Off
The default setting is “Off”.