Skip header
 

Placing Originals

Important

  • Place one original at a time on the original table.

  • When inserting an original, push it lightly against the rollers. Pushing it with force may cause an original jam.

  • Once an original start to feed in, do not push or pull it. This may damage the original.

  • If the original's front or rear edge is badly curled, smooth it out with both hands before scanning. If the original is inserted as is, it may be damaged.

  • When the machine is printing on paper that requires a long time for the ink to dry, such as translucent (vellum) paper, wait until each job has finished printing before loading the next original. If you load the next original while the machine is printing, the original might touch the printout and be stained with ink.

  • Be sure not to place anything other than originals on the original table.

  • Load the original only after the machine is ready.

Note

  • Place originals after any correction fluid or ink has completely dried. Not taking this precaution will result in a dirtied exposure glass and blemished copies.

  • Dust and residue from originals drawn with a pencil can result in a dirtied exposure glass and blemished copies. Use the carrier sheet for this type of original.