Skip header
 

Placing originals on the original table

1Press [Home] (Operation panel screen illustration) at the bottom of the screen in the center.

2Press the [Copy] or [Scanner] icon.

Make sure that “Please wait.” message disappears from the screen.

3Adjust the original guides to the original size.

Adjust the original guides so they are the same distance from the center of the original table.

Make sure that the original guides are flush against the original. Do not push the original guide side fences with force.

Original table illustration

4Using both hands, carefully insert the original between the original guides, scan side down.

Push the original so that it makes light contact with the feed rollers.

Support the original with your hands until it feeds in.

Original table illustration

Note

  • After inserting an original, do not try to handle it.

  • When loading long or thick originals, use both hands to support the original as it feeds until half of it is scanned so feeding is not interrupted.

  • When placing rolled originals, use the output basket. For details, see Placing rolled originals.

  • You can change the original feed delay setting if originals are repeatedly feeding in slanted, or if you need to adjust the delay for the type of originals you are using. For details, see "System Settings", Connecting the Machine/ System Settings.