Parameter Settings

Each User Parameter has a set of switches, and each of the switches consist of eight bits, whose values are "0" or "1". The right most bit is bit 0 and the left most is bit 7. You can adjust the settings to match your needs by switching the value of bits between "0" and "1".

• Switch 02

  0	0	1	1	1	0	1	1
  7	6	5	4	3	2	1	0

Automatic printing of the Communication Result Report

• 0: Off

• 1: On

See Communication Result Report.

Automatic printing of the journal

• 0: Off

• 1: On

See Printing the Journal.

Automatic printing of Communication Result Report when an error occurs while automatic printing of Communication Result Report is disabled

• 0: Off

• 1: On

See Communication Result Report.

Receive Service Call (SC) Condition (Substitute Reception during service call)

• 0: Possible (Substitute RX)

• 1: Not possible (Reception off)

Substitute the reception when the machine cannot print (because paper is jammed, all paper trays have run out of paper, toner is empty, or all paper trays are out of order)

• 00: Enabled Unconditionally (Free)

• 01: Enabled when Own Fax Number is received

• 11: Disabled (Reception off)

See Substitute Reception.

Empty tray alert (Paper Empty Warning) even when one paper tray is empty

• 0: Off

• 1: On

See "Messages Displayed When Using the Facsimile Function", Troubleshooting.

Reset when function changed

• 0: Off

• 1: On

Selecting the available paper feed tray

(Only the numbers listed below can be entered)

• 001: Tray 1

• 010: Tray 2

Whether or not to select the available paper feed tray

• 0: Off

• 1: On

Whether you need to press [Add Dest] after specifying a destination with the destination key when broadcasting

• 0: Not necessary

• 1: Necessary

See Preventing broadcast errors.

Whether or not to reset the settings when original is scanned

• 0: On

• 1: Off

Detect a dial tone before sending faxes when using the telephone line (LINE)

• 0: Not detect (Off)

• 1: Detect (On)