Skip header
 

Top Page > Advanced Printing > Memory/Class > Memory Mode > Stack memory mode

Stack memory mode

Important

  • You can make prints for up to 30 classes at one time.

  • To use Stack Memory mode, set Memory Mode to [Stack] by using the User Tools. For details, see 4 Mode Setting.

1Press the [Memory/Class] key.

Memory/Class key illustration

2Use the [Left arrow key] or [Right arrow key] key to select [Memory], and then press the [OK] key.

Operation panel screen illustration

3Use the number keys to enter the number of prints you want for each class, and then press the [Sharp] key.

Operation panel screen illustration

Repeat this step until you have entered the number of prints you want for all your classes.

4Press the [OK] key.

5If you want to use the optional tape dispenser, turn on the tape dispenser switch.

6Set your original.

7Make sure the [Master Making] mode select key is lit.

If it is not lit, press the [Master Making] mode select key.

Master Making mode select key illustration

8Press the [Start] key.

Start key illustration

9Printing starts automatically after the trial print.

Note

  • If you want to check the image before printing, press the [Auto Cycle] key before pressing the [Start] key, in order to disable Auto Cycle mode. See When Auto Cycle Mode Is Off.