4 Mode Setting

1

Auto Cycle ON/OFF

You can specify whether to set Auto Cycle to be [ON] or [OFF] when the power is turned on.

Default: [ON]

2

Ignore Paper Size

If you are making prints on paper of custom sizes, you can set the paper size detection to ignore.

Default: [Do not Ignore]

3

No Orig.Size(ADF)

If you are setting long originals in the ADF, you can set the original detection to ignore.

Default: [Do not Ignore]

4

No Orig. Size

If you are setting long originals on the exposure glass, you can set the original detection to ignore.

Default: [Do not Ignore]

5

Background ON/OFF

If you make prints in Photo, Letter/Photo, or Tint mode, the background of the prints might appear dirty. In this case, you can select "Back. Correction" to improve the quality.

Default: [W/O Back.Correction]

6

Longer Paper

You can select [Use] to allow the use of paper longer than 432 mm (17.0 inches).

Default: [Do not use]

7

Combine/Repeat

You can choose to have Combine or Repeat selected by default when the power is turned on.

Default: [Combine]

8

Cancel Comb.

You can specify whether Combine/Repeat mode will be automatically cancelled when a print job is complete.

Default: [Do not cancel]

9

No. of Skip Feed

You can specify the number of drum rotations when Skip Feed mode is enabled. You can also specify whether to change the number of drum rotations temporarily by pressing the [Skip Feed] key. See Skip Feed Printing.

Default: [2]

10

Idlng for Q.Mode

You can specify the number of idle spins performed by the drum unit when Quality Start mode is enabled.

Default: [2]

11

Setting Q.Mode

If you select [Yes], the machine automatically perform a few idle spins when the power is turned on. If Auto Quality Start mode is set to [No], you can restore the additional prints by making additional prints or by using Manual Quality Start mode.

Default: [Yes]

12

No. of Q.start

You can specify the number of drum idle spins when Auto Quality Start mode is enabled.

To increase the print image density, increase the number of drum rotations. To change the number of idle spins, see Quality Start Mode.

13

Memory Mode

You can specify whether to set Memory mode or Stack Memory mode by default.

Default: [Normal] (Memory mode)

14

Auto Class

Under Class mode, the machine stops when a Class print job is complete. If Auto Class is specified, the machine stops for two seconds, and then performs the next class print job.

Default: [Stop]

15

Auto Rotation

When the orientation of your original differs from that of the paper, the machine automatically rotates the original image by 90° to match the paper orientation.

Default: [On]