When Auto Cycle Mode Is Off
Make sure the [Auto Cycle] key is not lit.
If it is lit, press the [Auto Cycle] key.
Make sure the previous settings have been cleared.
If the previous settings have not been cleared, press the [Clear Modes/Energy Saver] key.
Make sure the [Master Making] mode select key is lit.
If it is not lit, press the [Master making] mode select key.
Specify the necessary settings.
Press the [Start] key.
If necessary, press the [Proof] key to check the image before making prints.
Make sure the [Print] mode select key is lit.
If it is not lit, press the [Print] mode select key.
Enter the number of prints you want using the number keys.
Set a print quantity between 1 (minimum) and 9999 (maximum).
Press the [Start] key.
Printing starts automatically after the trial print.
To change the image position, see Sample Print and Adjustment
.To stop the machine during a multi print run, press the [Clear/Stop] key.
To reset the machine's settings to their default values when printing is complete, press the [Clear Modes/Energy Saver] key.
To clear the entered values, press the [Clear/Stop] key.
