ContentsPreviousNext |
You can specify when to send a fax to a specified destination. This function is useful for sending a fax to a destination in a different time-zone.
This function is available in memory transmission mode only.
Use [Send Later] to specify a transmission time within 24 hours.
You can use this function together with [Broadcast], [Polling RX], and [Transfer Request].
This function is available for Internet Fax.
Press the [Fax] key, and make sure the [Memory Trans.] indicator lights.
Normally memory transmission mode is selected.
Place the original.
16:00 Std 100% -Set Orig- Fax Only |
To change the scan settings, press the [Resolution] key, and then specify the settings.
Press the [Fax Options] key.
Press the [] or [] key to display [2 Send Later], and then press the [Yes] key.
2 Send Later OK=Yes |
Specify the time using the number keys, and then press the [Yes] key.
Send Later=20:00 |
If you make a mistake, press the [Clear/Stop] key, and then enter the correct number.
Specify the destination, and then press the [Yes] key.
(TX=Start) |
Press the [B&W Start] key.
The transmission starts at the specified time.
You can specify [Send Later] to send a fax at the same time as another fax specified by [Send Later]. If you do this, the fax specified earlier is sent first.
If you press the [Fax Options] key after step 5., you can specify [Send Later] to use it together with [Broadcast], [Transfer Request] , or [Polling RX].
After you specify the destination, you can also specify the SUB or SID Code. You can enter the SUB or SID Code using up to 20 digits.
You can store SUB or SID Codes as well as names and fax numbers in the Address Book.