Scanning Documents into an Application on a Computer Using TWAIN
Use the TWAIN scanner from a computer to scan the original placed on the machine into an application that supports TWAIN.
Connect the machine to the network and install the TWAIN driver in advance.
TWAIN supporting application
To use the TWAIN scanner, install an application that supports TWAIN on the computer. Various image editing applications support TWAIN. For the installation and operation procedure of each application, see the use manual provided with the application.
The TWAIN driver operates in 32-bit mode. On a computer running an operating system in 64-bit mode, use an application operating in 32-bit mode.
Connect the machine and computer in the same network segment as shown below.
The IP addresses of the machine and computer match except in the last number "ddd" in "aaa.bbb.ccc.ddd"
The machine is connected via the link local address when using IPv6
Basic Procedure for Using the TWAIN Scanner
Place the original on the machine.
Start a TWAIN supported application on the computer.
In some applications, specify the machine as the scanner to use in the setting screen such as the scanner settings.
Display the configuration screen of the TWAIN driver.
Specifying the original orientation.
![Driver screen illustration](../../scanner/image/dzc537.gif)
To display the scanned pages in the correct vertical orientation on the computer, specify the orientation that matches the orientation of the original placed on the machine in the TWAIN driver.
Select the location where the original is set in [Original Scan Method:].
Select [
] or [
] in [Orig.Orientn.:].
Specify [Orientation:].
When placing the original on the exposure glass
When placing the original in the ADF
Orientation to place the original
[Orientation]
Orientation to place the original
[Orientation]
When placing the original in the ADF, select [1 Sided], [2 Sided(Top to Top)] or [2 Sided(Top to Bottom)] in [Scan Settings:].
Configure the other scan settings according to the purpose of the scanned data.
For details, see the TWAIN driver Help.
Click [Scan].
If you are scanning another page, place it in the same location and continue scanning until all pages are scanned.
Placing the Original Comprising Different Sizes on the Scanner
You can place and scan pages in the same vertical size at one time using the ADF. A regular size page is detected automatically.
![](../../scanner/image/dzb522.gif)
To detect the page size to scan for each page, select [Auto detect(Mixed-size)] in [Original Size:].
To scan all pages of an original in the same size as the first page, select [Auto detect(Uni-size)] in [Original Size:].
You cannot use the blank page detection function when using the TWAIN scanner.