Skip header
 

When ejecting carbonless paper weighing 63 g/m2 or less to Finisher SR5110 or Booklet Finisher SR5120

When printing on carbonless paper weighing 63 g/m2 or less, set the banner support tray that is provided with the finisher on the finisher shift tray.

1Press the [Suspend / Resume] key on Finisher SR5110 or Booklet Finisher SR5120, and then remove the delivered paper.

See Removing prints from Finisher SR5110 or Booklet Finisher SR5120 during printing or when in standby state.

2Pull out the extension tray on the finisher shift tray 1 or 2.

Extension tray illustration

3Attach the banner support tray by inserting the protrusions on its underside into the holes on the finisher shift tray 1 or 2.

Banner support tray illustration

4In [Adjustment Settings for Operators], set [0671: Paper Alignment Angle on Shift Tray] to "10 deg".

5Press the [Suspend/Resume] key to resume printing.

Note

  • Depending on the brand of the paper being used, the paper may be ejected normally even when the banner support tray is not attached.

  • When the banner support tray is attached, output sheets may not be stacked neatly.

  • If you set [Finisher Output Tray Setting] to [Auto Change] and [Do not Stack Jobs], and change where to deliver the paper when the banner support tray is attached, multiple jobs may be delivered to and stacked on the same tray.

PreviousNext