Skip header
 

Erase Outside

Use this function to copy the original while erasing outside of a specified area.

You can specify the area to erase according to the original you are copying.

Illustration of Erase Outside

Important

  • You cannot use the bypass tray with this function.

To specify the area you do not erase, you have to define the value of X1, Y1, X2, and Y2 on the original. Measure the area you want to specify before entering the area settings.

Illustration of Erase Outside

1Specify the base point of the area (X1, Y1) and the size of the area (X2, Y2).

Each value can be specified in a range from 0 to 1220 mm (0.0 to 48.0 inches).

2Press [Edit / Stamp].

Operation panel screen illustration

3Press [Erase].

4Press [Erase Outside].

5Enter the length of [X1] with the number keys, and then press [Sharp].

Operation panel screen illustration

6Enter the length of [Y1] with the number keys, and then press [Sharp].

7Enter the length of [X2] with the number keys, and then press [Sharp].

8Enter the length of [Y2] with the number keys, and then press [Sharp].

9Press [OK] twice.

Note

  • When using this function with the reduce/enlarge function, the actual size will be the specified value multiplied by the reproduction ratio.

PreviousNext