Previous
Use this function to copy the original while erasing a specified area.
You can specify the area to erase according to the original you are copying.
You cannot use the bypass tray with this function.
To specify the area you want to erase, you have to define the value of X1, Y1, X2, and Y2 on the original. Measure the area you want to specify before entering the area settings.
Specify the base point of the area (X1, Y1) and the size of the area (X2, Y2).
Each value can be specified in a range from 0 to 1220 mm (0.0 to 48.0 inches).
Press [Edit / Stamp].
Press [Erase].
Select one of the areas from [Erase Inside 1] to [Erase Inside 5].
Enter the length of [X1] with the number keys, and then press [
].
Enter the length of [Y1] with the number keys, and then press [].
Enter the length of [X2] with the number keys, and then press [].
Enter the length of [Y2] with the number keys, and then press [].
Press [OK].
To specify multiple areas, repeat steps 4 to 9.
Press [OK].
When using this function with the reduce/enlarge function, the actual size will be the specified value multiplied by the reproduction ratio.
By combining [Erase Inside 1]–[Erase Inside 5], you can erase up to five areas at the same time.
