Skip header
 

Removing Scanning Jams (Type 2 model)

When the following message appears on the screen, follow the procedure below to remove the original jammed in the ARDF:

CAUTION


  • When removing jammed paper, make sure not to trap or injure your fingers.

1Open the ARDF cover.

Auto reverse document feeder illustration

2Gently pull the jammed original to remove it. Be careful not to pull the original too hard, as it may rip.

Auto reverse document feeder illustration

3If you cannot pull out the jammed original easily, move the lever slightly to the machine rear, and then raise it to unlock the paper feed roller.

Auto reverse document feeder illustration

4Lift the paper feed roller slightly and pull it out toward you.

Auto reverse document feeder illustration

5Gently pull the jammed original to remove it.

Auto reverse document feeder illustration

6If you cannot pull out the jammed original easily, raise the input tray to see if the original is jammed in the output area.

Auto reverse document feeder illustration

7Gently pull the jammed original to remove it.

Auto reverse document feeder illustration

8Put the paper feed roller back in with the roller part facing downwards.

Auto reverse document feeder illustration

9Lower the lever to lock the paper feed roller.

Auto reverse document feeder illustration

10Close the ARDF cover.

Auto reverse document feeder illustration

11Lift the ARDF, and if there is original remaining in the ARDF, gently pull the jammed original to remove it.

Be careful not to hold the input tray when lifting the ARDF, for the tray might be damaged.

Auto reverse document feeder illustration

12Close the ARDF.