Recalling the stored settings

Press the [Memory/Class] key.

Use the [] or [] key to select [Recall], and then press the [OK] key.

Use the [] or [] key to select the number you want to recall, and then press the [OK] key.

Confirm that the settings are correct, and then press the [OK] key.

To change the stored settings, use the [] or [] key to select the item that you want to change, and then use the number keys to overwrite the settings.

Set your original.

Make sure the [Master Making] mode select key is lit.

If it is not lit, press the [Master Making] mode select key.

Press the [Start] key.

Printing starts automatically after the trial print.