Storing class mode settings

Press the [User Tools] key.

Use the [] or [] key to select [3 Initial Setting], and then press the [OK] key.

Use the [] or [] key to select [7 Prog./Change:Clss], and then press the [OK] key.

Use the [] or [] key to select a number, and then press the [OK] key.

If the number is already registered, a message will appear to ask if you want to overwrite the stored settings. To overwrite, press the [OK] key. Otherwise, press the [Escape] key to return to the previous display, and then select another number.

Use the number keys to enter the number of prints you want, and then press the [] key.

Use the number keys to enter the number of classes you want, and then press the [] key.

Repeat Steps 5 and 6 to register all your classes.

Press the [OK] key.

Press the [Clear Modes/Energy Saver] key.

The contents that you have stored are now enabled.