Ethernet Configuration

If connecting the printer to a network using an Ethernet cable, set the necessary settings, depending on the network environment, on the control panel.

Web Image Monitor can be used for the settings related to the IP address.

The following table shows the control panel settings and their default values. These items appear in the [Network Setting] under [Host Interface] menu.

Setting Name	Value
IPsec	Off
IPv4 Config.	DHCP: Active IP Address: XXX.XXX.XXX.XXX ¹ Subnet Mask: XXX. XXX. XXX. XXX ¹ Gateway Address: XXX.XXX.XXX.XXX *¹
IPv6 Config.	IPv6: On IP Ad. (DHCP): XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX ¹ If the DHCP setting is enabled, the IPv6 address obtained from a DHCP server is displayed. Manual Address: Manual Address: 0000:0000:0000 Prefix Length: (0-128) 0 Gateway Address: 0000:0000:0000: Stateless Ad.: Address 1: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX ¹ Address 2: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX ¹ Address 3: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX ¹ Address 4: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX ¹ Link-local Ad.: XXXX: XXXX: XXXX: XXXX: XXXX ¹ DHCP: Off
MAC Address	XX-XX-XX-XX-XX-XX *¹
Ethernet Speed	Auto Select

*¹ "X" indicates a unique address number for your printer.

If [DHCP] is in use, the IP address, subnet mask, and gateway address are all set automatically.
Each printer has a unique [MAC Address] value.
Set the Ethernet speed if necessary.