Receiving an IP Address for IPv4 Automatically (DHCP)

When you use this printer protocol in the DHCP environment with IPv4 protocol, select [DHCP] following this procedure.
When [DHCP] is selected, you cannot make settings for the following items:
- IP Address
- Subnet Mask
- Gateway Address
Consult your network administrator for information about making network settings.

Press the [Menu] key.
Press the [] or [] key to display [Host Interface], and then press the [OK] key.

Menu: Host Interface
Press the [] or [] key to display [Network Setting], and then press the [OK] key.

Host Interface: Network Setting
Press the [] or [] key to display [IPv4 Config.], and then press the [OK] key.

Network Setting: IPv4 Config.
Press the [] or [] key to display [DHCP], and then press the [OK] key.

IPv4 Config.: DHCP
Press the [] or [] key to select [Active], and then press the [OK] key.

DHCP: Active

The address will be detected by the printer
Press the [Menu] key.
If you are requested to restart the printer, turn off the printer, and then turn it back on.
Print a configuration page to confirm the settings made.

For details about printing the configuration page using control panel, see Test Printing.