Setting the Ethernet Speed

You can set the speed that the printer will use for Ethernet communication. For normal usage, the default setting [Auto Select] is suitable and does not need to be changed. This setting allows two connected interfaces to automatically determine the optimum speed that they will communicate at.

Router/HUB	Printer
Router/HUB	[10Mbps Half D.]	[10Mbps Full D.]	[100Mbps Half D.]	[100Mbps Full D.]	[Auto Select]
10Mbps Half Duplex
10Mbps Full Duplex
100Mbps Half Duplex
100Mbps Full Duplex
auto-negotiation (auto selection)

Connection cannot be established if the selected Ethernet speed does not match your network's transmission speed.
The use of this feature is recommended. To use it, select [Auto Select].

Press the [Menu] key.
Press the [] or [] key to display [Host Interface], and then press the [OK] key.

Menu: Host Interface
Press the [] or [] key to display [Network Setting], and then press the [OK] key.

Host Interface: Network Setting
Press the [] or [] key to display [Ethernet Speed], and then press the [OK] key.

Network Setting: Ethernet Speed
Press the [] or [] key to select the Ethernet speed, and then press the [OK] key.
Press the [Menu] key.
Print a configuration page to confirm the settings made.

For details about printing the configuration page using control panel, see Test Printing.