Skip headerimageimage
ContentsPreviousNextHelp

Sending a Fax by Memory Transmission Mode

You can use memory transmission mode to send both normal and Internet Faxes. You can also use this mode to send a fax at a specified time or to multiple destinations.

Important

The display shows the percentage of free memory space for storing originals.

  1. Press the [Fax] key, and make sure the [Memory Trans.] indicator lights.

    panel keys illustration

    Normally memory transmission mode is selected.

    If it is not, immediate transmission mode is selected. Press the [Memory Trans.] key.

  2. Place the original.

    16:00    Std    100%
     -Set Orig- Fax Only

    To change the scan settings, press the [Resolution] key, and then specify the settings.

  3. Specify the destination.

                      
    SUB=Down arrow key            [1]

    If you press a Quick Dial key, the destination assigned to it appears on the display and transmission begins automatically. You do not have to press the [B&W Start] key as in step 4.. (below).

    If you make a mistake, press the [Clear/Stop] key, and then enter the correct number.

  4. Press the [B&W Start] key.

    panel keys illustration

    The transmission starts.

    After transmission, the initial screen appears.

    To cancel a fax during sending, press the [Clear/Stop] key, and then remove the original.

Note

Reference