Settings to Send Fax

You can specify 1 to 1 for the density of scanned originals to be sent.

The default setting is “0” (the halfway/medium setting).

Select resolution for scanning originals.

Select [Std], [Detail], [Fine], or [Photo] as the scanning resolution.

Thin characters (thin horizontal lines) may get distorted if sent in the mode. Select for sending text containing thin characters (thin horizontal lines).

Characters containing thin horizontals might appear distorted if sent in [Std] mode. Select [Detail] when sending text containing such characters.

The default setting is “Std”.

You can specify whether to always use Memory TX.

The default setting is “On”.

The Fax Header is printed as the header of every fax you send. The transmitter's own Tel number is printed as the header.

Enabling of the redial function, and the [Interval] and [Times] settings for redialing depend on the country you select in [Country] in [System Settings].

If the machine cannot connect because the line is busy, or if data cannot sent due to transmission error, the machine redials up to 10 times at intervals of 1 to 99 minutes.

However, if [TX Error] is reported in the journal, the machine redials only once.

The default setting is “On”.