Input / Output

This section describes the settings in the [Input / Output] menu under [Copier / Document Server Settings].

Introduction of Two Types of Setting Screens (Standard/Classic)

Items	Description
Switch to Batch	You can select to have [Batch] mode or [SADF] mode displayed when you press [Original Settings]. Default: [Batch] Copying a Separately Scanned Original as a Single Document
SADF Auto Reset	In SADF mode, you can specify the time to place an original in the ADF after the previous original has been fed. When the specified time has passed, the original will not be fed automatically. Default: [5 second(s)] Copying a Separately Scanned Original as a Single Document
Rotate Sort: Auto Paper Continue	You can specify whether the machine continues copying using the paper set in another paper tray when paper of the required orientation runs out during rotate sort. Default: [Off]
Memory Full Auto Scan Restart	When the memory becomes full while scanning originals, the machine can make copies of scanned originals first, and then automatically proceed scanning remaining originals. When you specify [On], all pages are copied and separately sorted into two halves according to the output timing of scanning. When you specify [Off], the machine stops operation. Remove the first copy pages, and you can avoid sorting the first half pages and second half pages separately. Default: [Off]
Letterhead Setting	You can specify whether to use letterhead paper. When you specify [On], the paper is not rotated to prevent copying onto the letterhead paper in an incorrect orientation. Default: [Off]
Stapleless Position (This item is enabled only when the [Copier (Classic)] is used.)	You can specify whether to display the Stapleless Stapler key on the initial screen of the Copy function when Finisher SR3260 is installed. To display the key, select [Stapleless Stapler]. Default: [Stapleless Stapler] Stapling Copied Pages
Staple Position (This item is enabled only when the [Copier (Classic)] is used.)	You can specify which staple-type key is displayed on the initial screen of the Copy function. You can specify up to four staple types. The selectable staple type depends on the installed finisher. Stapling Copied Pages
Punch Type (This item is enabled only when the [Copier (Classic)] is used.)	You can specify which punch-type key is displayed on the initial screen of the Copy function. When 2 & 4 hole punch unit is installed: Default for Punch Type 1: [Punch: 2 Holes Left] Default for Punch Type 2: [Punch: 2 Holes Top] When 2 & 3 hole punch unit is installed: Default for Punch Type 1: [Punch: 3 Holes Left] Default for Punch Type 2: [Punch: 3 Holes Top] When 4 hole punch unit is installed: Default for Punch Type 1: [Punch: 4 Holes Left] Default for Punch Type 2: [Punch: 4 Holes Top] Punching Holes on the Copied Pages
Simplified Screen: Finishing Types (This item is enabled only when the [Copier (Classic)] is used.)	You can select the finishing function keys displayed on the Copy screen. Default: Finishing Type 1, Finishing Type 2, Finishing Type 3: [Do not Display]
Z-fold Output Tray	You can specify the tray to which Z-fold paper is delivered. Default: [Folding Unit Tray]
Half Fold	Specify the fold orientation and print side for half fold. Default Fold Orientation: [Right - Left] Print Side: [Inside] Folding Copied Sheets
Letter Fold-out	You can specify the fold and page opening direction for Letter Fold-out. Default Fold Orientation: [Right - Left] Open Orientation: [Open to Right] Folding Copied Sheets
Letter Fold-in	You can specify the fold and page opening direction and print side for Letter Fold-in. Default Fold Orientation: [Right - Left] Open Orientation: [Open to Right] Print Side: [Outside] Folding Copied Sheets