User GuideIM C2000/C2500/C3000/C3500/C4500/C5500/C6000 series

Sending Internet Faxes without Using SMTP Server

The machine interprets the string after "@" in the destination address as an SMTP server, and sends the fax without going through the actual SMTP server. This method reduces the load on the SMTP server, and shortens the time required to go through the server.

  • The destination fax, computer, or server must support reception by SMTP, and the reception protocol must be set to SMTP.

  • Specify the destination by its host name when the destination host name is registered on the DNS server. Specify the destination by its IP address when it is not registered on the server.

  • Specify the host name when sending an Internet Fax over an IPv6 network.

1Press [Fax] on the Home screen.

Operation panel screen illustration

2Select [Internet Fax] on the fax screen.

Operation panel screen illustration

3Place the original in the Auto Document Feeder (ADF) or on the exposure glass.

Setting an Original to Send by Fax on the Scanner

4Press and then select [Enter Using Keyboard].

Operation panel screen illustration

5Enter the destination.

When specifying the host name of the destination

xxxx@hostname.domain

  • If the e-mail assigned to the destination device is "abc@domainname.com" and the host name is "HOST", for example, specify as follows:

    abc@HOST.domainname.com

When specifying the IP address of the destination

xxxx@[destination-IP-address]

or

xxxx@destination-IP-address

  • If the e-mail assigned to the destination device is "abc@domainname.com" and the IP address is "192.168.1.10", for example, specify as follows:

    abc@[192.168.1.10]

    or

    abc@192.168.1.10

6Press [Details] on the fax screen.

Operation panel screen illustration

7Select the address that you specified in Step 7, and then press [Send via SMTP Srv.]

Operation panel screen illustration

8Select [No] and then press [OK].

9Press [Settings][Sender] to specify the sender.

When a login user is operating the machine, the login user becomes the sender.

11Press [Start].

Note

  • The setting to use the SMTP server registered in the address book will be applied when you select a destination from the address book.

  • When using this function, an error e-mail is not sent from the server when a transmission cannot be performed correctly.