Skip header
 

When ejecting an envelope of 240 × 332 mm to the finisher

When sending an envelope of 240 × 332 mm to the finisher, attach the Z-fold support tray to the finisher shift tray.

1Attach the Z-fold support tray by inserting the two protrusions on its underside into the holes on the finisher shift tray.

Finisher SR5050 and Booklet Finisher SR5060

  • Finisher shift tray

    Z-fold support tray illustration

Finisher SR5110 and Booklet Finisher SR5120

  • Finisher shift tray 1 or 2

    Z-fold support tray illustration

    If you set [Finisher Output Tray Setting] to [Auto Change] and [Do not Stack Jobs], and change where to deliver the paper when the Z-fold support tray is attached, multiple jobs may be delivered to and stacked on the same tray.

Note

  • Prints may not stack properly when the Z-fold tray is attached.