Skip header
 

To eliminate curling without using the decurler unit, lower the heat roller temperature.

Lowering the temperature may result in:

Note

  • To adjust the following settings, pre-register the type of paper in use as a custom paper. For details about registering custom papers, see "Specifying a Custom Paper", Preparation.

  • To use the decurler unit, specify 0304: [Correct Output Paper Curl] in the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu.

  • After performing the solution, it is recommended to perform the color calibration of the external controller.

  • Check the toner fusibility as follows:

    • The printed image does not come off.

    • The toner does not come off even if it is lightly rubbed by a nail.

    • The toner does not come off even if it is rubbed by the cloth for cleaning the contact glass.

1In [Advanced Settings] for the custom paper you are using, select 1232: [Fusing Temperature], and then decrease the value in the following corresponding settings by 5°C.

  • [BW/FC/FCS]

    [Heat Roller Temp]

  • [FCS]

    [Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]

  • [S]

    [Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]

  • [BW/FC/FCS: Fuser Setting HQ]

    [Heat Roller Temp]

  • [FCS: Fuser Setting HQ]

    [Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]

  • [S: Fuser Setting HQ]

    [Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]

2Print a full-page solid-fill image. Has the problem been resolved?

Yes

Finished!

No

Further reduce the value by 5°C until the problem is resolved. Adjust the temperature while checking fusibility.

If the problem persists, contact your service representative.
PreviousNext