Notes on Configuring the Ring Binding

Ring Binding will be canceled or a job reset may occur if:

• The machine is configured to continue printing manually.

• [Auto Continue] is specified.

• Tray A is specified as the source tray.

• [Driver / Command] is selected in [Tray Setting Priority] for the specified source tray.

• Slip Sheets is specified.

• Separation Sheets is specified.

• The staple function is specified.

• The punch function is specified.

• The fold function is specified.

• Paper is ejected with its printed side facing up.

• Perfect Binding is specified.

• Ring binder is not attached.

• Ring combs have run out.

• The hole punch receptacle is full.

• Ring Binding cannot be used for the selected tray, paper size, or paper type.

• Ring Binding cannot be used for the selected paper orientation.

• The number of printed sheets exceeds 50 when Ring Binding with 50-sheet type ring combs is specified.

• The number of printed sheets exceeds 100 when Ring Binding with 100-sheet type ring combs is specified.

• Sheets of paper to be bound with 50-sheet type ring combs are thicker than 50 sheets of plain paper.

• Sheets of paper to be bound with 100-sheet type ring combs are thicker than 100 sheets of plain paper.

• Ring combs are set in reverse orientation.

• Ring combs of a size that is not supported by the ring binder are used.

• The punch unit is not attached.

• Different types of ring combs (50-sheet type and 100-sheet type ring combs) are used together.

The following functions will be canceled when specified with Ring Binding at the same time:

• Stack

• Extended Auto Tray Switching