WLAN: EasySetup/Direct Con
You can set up wireless LAN automatically using Wi-Fi Protected Setup.
Default: [Push Button Method]
Communication Mode
You can specify the transmission mode for wireless LAN.
Default: [Infrastructure Mode]
SSID Setting
You can specify the SSID settings to distinguish the access point in [Infrastructure Mode] or [802.11 Ad-hoc Mode].
The characters that can be used are ASCII 0x20-0x7e (32 bytes).
Ad-hoc Channel
You can specify the channel to use when [802.11 Ad-hoc Mode] has been selected. Set the channel that matches the type of the wireless LAN being used.
Default: [11]
Security Method
You can specify whether or not to enable the encryption method and security method when the encryption is enabled.
Default: [Off]
Off
WEP
Press [Details], and then enter the WEP key using hexadecimal and ASCII characters.
WPA2
Press [Details], and then select the Authentication Method.
When you select WPA2, the Encryption Method is set to CCMP (AES) and cannot be changed.
Select one of the following Authentication Methods:
WPA2-PSK, WPA2
When you select WPA2-PSK, enter a passphrase (from 8 to 63 characters).
Direct Connection Settings
Specify the Wi-Fi Direct function.
Device Name(SSID)
Enter up to 23 characters for the device name.
Connection Password
Enter 8 to 63 characters for the connection password.
Display IPv4 Address
You can check the printer's IPv4 network address for Wi-Fi Direct connection.
Connection Status
You can check the machine's direct connection status with other devices.
Wireless LAN Signal
You can check the signal strength when using wireless LAN.
Country/Region
The list of countries and regions is displayed.
Specify the correct country or region, and then press [OK].
Specify the country or region in which the machine is used correctly before using the wireless LAN.
You may violate the local law or regulation if you specify the setting incorrectly.
Restore Defaults
You can reset the wireless LAN settings to their default.