Previous
Machine IPv4 Address
You can specify whether to set the IPv4 address automatically or manually.
Default: [Auto-Obtain (DHCP)]
Auto-Obtain (DHCP)
When DHCP is set to On, the IPv4 address, subnet mask address, and gateway address cannot be changed. To change them, set DHCP to Off. Contact your administrator for information about the network configuration.
Specify
IP Add.
Manually specify the IPv4 address.
Default: [11.22. 33.44]
Subnet M
Manually specify the subnet mask.
Default: [0.0.0.0]
Gateway
Manually specify the gateway address.
Default: [0.0.0.0]
IPv6 Stateless Setting
You can specify whether to enable or disable stateless IPv6 address auto configuration.
Default: [Active]
Effective Protocol
You can specify the effective protocol.
IPv4
Default: [Active]
IPv6
Default: [Inactive]
@Remote Service
Default: [Active]
Firmware Update (IPv4)
Default: [Active]
Firmware Update (IPv6)
Default: [Active]
Ethernet Speed
You can specify the network speed to operate the printer. If a communication error occurs because of compatibility problems with the hub, select a speed suitable for your network environment.
In order to reduce power consumption of network devices, the default Ethernet speed of the printer does not exceed 100BASE-TX (100 Mbps). If you want to communicate using a higher speed, select [Auto Select: Enable 1Gbps] to enable 1000BASE-T (1Gbps) communication.
Default: [Auto Select: Disable 1Gbps]
IEEE802.1X Auth.(Ethernet)
You can specify IEEE 802.1X Ethernet authentication. For details about IEEE 802.1X authentication, see "Configuring IEEE 802.1X Authentication", Security Guide.
Default: [Inactive]
Restr.IEEE802.1X Auth.Def.
You can restore the default IEEE 802.1X setting.
LAN Type
You can select Ethernet or Wireless LAN.
Default: [Ethernet]
Permit SSL/TLS Comm.
You can set up encrypted communication for SSL/TLS. If you set to [Ciphertext Only], install the SSL certificate for the printer.
Default: [Ciphertext/Cleartext]
