Skip header
 

Copies can be folded in the following ways: Z-fold, Half Fold, Letter Fold-out, Letter Fold-in.

Important

  • You cannot use the bypass tray with this function.

Note

  • You cannot use the following paper with this function:

    • Internal Multi-Folding unit

      • Postcards

      • OHP transparencies

      • Thick paper

      • Translucent paper

      • Label paper (adhesive labels)

      • Envelopes

    • Booklet Finisher SR3220

      • OHP transparencies

      • Thick paper

      • Translucent paper

      • Label paper (adhesive labels)

      • Envelopes

    • Booklet Finisher SR3240

      • OHP transparencies

      • Thick Paper 3, 4

      • Translucent paper

      • Label paper (adhesive labels)

      • Envelopes

  • Copying will stop if the number of copies exceeds tray capacity. If this happens, remove copies from the folding unit tray to resume copying.

  • The printed side of the paper may occasionally be scratched or stained with toner depending on the paper and the conditions of the machine's environment.

  • Print quality over fold lines might be reduced. This is due to cracking within the fused toner. Loss of surface along fold lines can also occur with some types of paper. To avoid possible wastage, print a single test sheet before beginning a print run.

  • The capacity of the folding unit tray may vary depending on the fold settings and the condition of the paper.

  • For details about which sizes and weights of paper that can be folded, see "Specifications", Maintenance and Specifications.

  • You can specify the fold-back position in [System Settings]. For details about how to adjust the fold-back position, see "System Settings", Connecting the Machine/ System Settings.