Skip header
 

Specifying the Length of Copy Paper Cut

Specify the length to cut the paper loaded in the paper input location.

Important

  • You cannot cut the paper in the paper bypass location.

The following paper cut methods are available:

Synchro Cut

Cuts the paper at the same length as the original. If the copy is enlarged or reduced, the machine calculates the appropriate length for the magnification ratio and cuts the paper.

Preset Cut

Cuts the paper at a preset size, regardless of the size of the original. You can use this to copy different sized originals to the same size.

Variable Cut

Cuts the paper to the size entered.

Note

  • The minimum cut length is 210 mm (8.3 inches), and the maximum length is 15,000 mm (590.5 inches) for plain paper of 841 mm (34 or 36 inches) or more in width. For other paper, the maximum length is 3,600 mm (141.8 inches). If the length you specify exceeds the maximum, the paper will be fed in at a slant, resulting in poor copy quality and wrinkled paper.

  • When copying originals that are larger than A0 (E), make sure that there is enough ink to finish the job. If the ink runs out while copying, and new ink is added, copying starts from the beginning, not from where it stopped.

  • When copying originals that are larger than A0 (E) onto two or more sheets of paper, it takes time until the next copy starts.