System(EM)

Specify whether or not to eject paper when the paper eject command is received and there is no data to print. The machine's behaviors for each setting when the paper eject command is received are as follows:

• On

  Ejects paper even when it is blank.

• Space

  Ejects paper if a space code (20H, A0H, or 8140H) is received before the paper eject command. The machine will not eject paper if any other codes are received.

• Off

Default: [Off]

Specify whether or not the machine prints the data stored in the machine forcefully when no data is received from a computer for a certain period of time.

For example, you can set the machine to automatically print data that has no page break code and needs [Form Feed] to be pressed to print. To set the machine to start printing automatically, specify the time the machine waits before it starts printing when no data is received.

For example, when [10 seconds] is selected, the machine starts printing forcefully after data transmission has been interrupted for 10 seconds. The machine automatically ejects paper after the specified period of time has elapsed. If the data transmission is interrupted for longer than the specified duration, part of the data will be printed on a different sheet of paper.

The available options are as follows:

Off, 10 seconds, 15 seconds, 20 seconds, 25 seconds, 60 seconds, 300 seconds

Default: [Off]

Specify the custom size for paper tray 1 and 2.

You can specify a dimension between 210 and 914 mm horizontally and between 210 and 15,000 mm vertically.

Default: "210" × "210" mm