[Mode Settings]

1

[Auto Cycle]

You can specify whether to set [Auto Cycle] to be [On] or [Off] when the power is turned on.

Default: [On]

2

[Background Correction]

If you make prints in Photo, or Text/Photo mode, the background of the prints might appear dirty. In this case, you can select [Background Correction] to improve the quality.

Default: [Correct text mode only]

3

[Longer Paper]

You can select [Use] to allow the use of paper longer than 390 mm (15.3 inches).

Default: [Do not Use]

4

[Combine/Repeat Priority]

You can choose to have Combine or Repeat selected by default when the power is turned on.

Default: [Combine Priority]

5

[Cmb/Img Repeat Sep. Line]

You can specify the type of separate line of combine and repeat.

Default: [None]

6

[Cancel Combine Setting]

You can specify whether Combine/Repeat mode will be automatically cancelled when a print job is complete.

Default: [Do not Cancel]

7

[Skip Feed]

You can specify the number of drum rotations when Skip Feed mode is enabled. You can also specify whether to change the number of drum rotations temporarily by pressing the [Skip Feed/A3 Paper Feed] key. See Skip Feed / A3 Paper Feed.

Default: [2]

8

[Memory Mode Setting]

You can specify whether to set Memory mode or Stack Memory mode by default.

Default: [Normal] (Memory mode)

9

[Auto Class]

Under Class mode, the machine stops when a Class print job is complete. If [Auto Class] is specified, the machine stops for two seconds, and then performs the next class print job.

Default: [Normal]

10

[Set Pos. (Exp. Glass)]

You can select between [Left Back] and [Center] as the set position of the original to be placed on the exposure glass.

Default: [Left Back]