Skip header
 

This section explains the procedure for stamping originals that are scanned from the ADF. The stamp indicates the originals have been scanned.

Important

  • For details about the optional units required for this function, see "Functions Requiring Optional Configurations", Getting Started.

When scanning a document using ADF, the machine can stamp a circle mark at the bottom of the original. When scanning a two-sided document, the document is marked at the bottom of the front page and top of the rear page.

This function is useful when you want to distinguish scanned originals.

Illustration of stamp

1Press [Send Settings].

Operation panel screen illustration

2Press [Down arrow key] three times and then press [Stamp].

3Press [OK].

Note

  • Last pages are stamped even if you selected not to scan the last page.

  • Stamping may continue if scanning is interrupted, depending on the cause of interruption.

  • When the stamp starts getting lighter, replace the cartridge. For details, see "Replacing the Stamp Cartridge", Maintenance and Specifications.

PreviousNext