Maintenance: Print

Select [Plain Paper 1] or [Plain Paper 2] depending on the weight of plain paper.

If in [System Settings], [Tray Paper Settings], you set “Paper Thickness” to [Plain Paper] for each tray's [Paper Type], you must then select [Maintenance], [Plain Paper Setting] and specify either [Plain Paper 1] or [Plain Paper 2], depending on the thickness of the loaded paper.

Select [Plain Paper 1] when the paper weight is 60–74 g/m² (16–20 lb. Bond).

Select [Plain Paper 2] when the paper weight is 75–81 g/m² (20 lb. Bond).

In [Tray Paper Settings], for each tray's [Paper Type] you can specify "Paper Thickness". For details about paper thickness, see Supported Paper for Each Input Tray.

Default: [Plain Paper 2]

Use this function to specify the timing to notify user when supplies need to be replaced. Settings can be made separately for photo conductor unit, intermediate transfer unit, or fusing unit.

• Black Photoconductor Unit

  • Notify Sooner

  • Normal

  • Notify Later

  Default: [Normal]

• Color Photoconductor Unit

  Default: [Normal]

• Intermediate Transfer Unit

  Default: [Normal]

• Fusing Unit

  Default: [Normal]

You can specify whether or not to continue printing after the following components have exceeded their recommended service life.

• Continue Printing

• Stop Printing

Default: [Continue Printing]