Previous
To use NetWare, select the appropriate NetWare frame type from the following.
Auto Select
Ethernet II
Ethernet 802.2
Ethernet 802.3
Ethernet SNAP
Usually, you can use the default (Auto Select). When you first select [Auto Select], the frame type detected by the printer is adopted. However, if your network can use more than two frame types, the printer may fail to select the correct frame type with [Auto Select] selected. In this case, select the preferred frame type.
Press [Interface Settings] on the [System Settings] screen.
For details about how to access the [System Settings] screen, see Displaying the Printer Configuration Screens Using the Control Panel
.
Press [Network].
Press [
] repeatedly until [NW Frame Type] appears.
Press [NW Frame Type].
Select the frame type to use, and then press [OK].
Press the [User Tools] key.
Print a configuration page to confirm the settings.
For details about printing the configuration page, see Test Printing
.
