Applies two folds to create three equal panels (outer panels folding inward).
Press [Output/ Customize Function/ Finisher].
Press [Fold].
Press [Letter Fold-in].
Press [Change].
Select Fold Orientation, Open Orientation, Print Side, and Multi-sheet Fold.
Press [OK] twice.
Place the originals, and then press the [Start] key.
Folded documents are delivered to the multi-folding unit only.
You can specify the fold-back position in 1 mm (0.04 inches) increments under Letter Fold-in Position in User Tools. For details about Letter Fold-in Position, see “System Settings”, Network and System Settings Reference.
The Multi-sheet Fold function can fold a maximum of three sheets at a time.
When you enable the Multi-sheet Fold function (by setting it to [On]), the Sort function is automatically applied also. However, the Mixed Sizes function is not available while the Multi-sheet Fold function is enabled.
If the Booklet or Magazine function is set, the settings for those functions have priority.
The following copier functions are not available when the Letter Fold-in function is enabled:
Punch
Staple
If you apply the Multi-sheet Fold function with letter fold-in to B5 JIS size paper, the folded sheets will be different in size to sheets folded without the Multi-sheet Fold function.
Multi-sheet Fold not applied
Multi-sheet Fold applied
Wrinkling can occur when applying letter fold-in to B4 JIS, A3
, 81/2 × 14
, 11 × 17
, 12 × 18
, 8K
, or larger sheets. In some cases, you may have to use A4
sheets or smaller when applying folds in combination with the reduction function.