Skip header
 

Displaying the destination prior to transmission

To prevent documents being sent to the wrong destination, you can configure the machine to display the destination again after it has been entered and before the file is sent.

If you want to enable this function, contact your service representative.

Note that the entered destination will not be displayed again if you are sending the fax by any of the following means:

1Specify the destination.

Operation panel screen illustration

If you make a mistake, press the [Clear/Stop] key, and then enter the number again.

2Press the [Start] key.

Operation panel screen illustration

Displays the destination and the transmission settings.

Operation panel screen illustration

To change the destination, press [Exit], and then specify the destination again.

3Press the [Start] key again.

Transmission starts.

After transmission, the standby display appears.