Cleaning the Registration Roller and the Paper Tray

The surrounding registration roller or paper tray might get dirty with paper dust when using paper other than standard paper.

If white spots appear on the printout due to paper dust, wipe the paper tray and registration roller.

The inside of the machine could be very hot. Do not touch the parts with a label indicating the "hot surface". Otherwise, an injury might occur.

Do not pull out the paper tray forcefully. If you do, the tray might fall and cause an injury.

Do not put your hands inside the printer when the input tray is removed. Some internal parts become hot and are a burn hazard.

Turn off the power switch.
Pull out the plug from the socket. Remove all the cables from the printer.
Lift and pull Tray 1 carefully, and then pull it out with both hands.
Place the tray on a flat surface. When there is paper in the tray, remove paper.
Wipe the inside of the paper tray with a cloth.
Push the metal plate down until it clicks into place to lock.
Slide Tray 1 along the rails, and push it carefully all the way into the printer.
Pull Front Cover Open Lever, and then open the front cover with both hands carefully.
The registration roller is set in the position shown by the illustration.
Do not touch the transfer roller.
Using a cloth, wipe the metal registration roller.
Clean the registration roller if printed paper becomes smeared after clearing a paper jam.
Close the front cover with both hands carefully.
Insert the plug of the power cord into the wall socket securely. Connect all the interface cables that were removed.
Turn on the power switch.