Skip header
ManualsContentsPreviousNextHelp

Loading legal size paper

This section describes how to load Legal size paper into the printer.

The same procedure applies to A4 paper or larger.

Important

  1. Remove the rear cover using a coin.

    Rear side of the printer illustration

  2. Pull Tray 1 carefully, then hold it with both hands and pull it out.

    Standard paper feed tray illustration

    Place the tray on a flat surface.

  3. Push the metal plate down until it clicks into place to lock.

    Standard paper feed tray illustration

  4. Pinch the extender in the "PUSH" direction, and then pull out the extender until it stops (you will hear a click).

    Standard paper feed tray illustration

    After extension, make sure the arrows on the extender and tray are aligned.

    Standard paper feed tray illustration

  5. Pinch the clip on the side paper guide, and then slide it to match the legal paper size.

    Standard paper feed tray illustration

  6. Pinch the front end paper guide and slide it inward to match the legal paper size.

    Standard paper feed tray illustration

  7. Fan the paper before loading paper in the tray.

    Illustration of fan the paper

  8. Load the new paper stack print side up.

    Standard paper feed tray illustration

    Make sure paper is not stacked higher than the upper limit (upper line) marked inside the tray.

    Slide the guides inward until they are flush against the paper's sides.

    Make sure the paper is not stacked higher than the projection on the side paper guides.

  9. Carefully push Tray 1 straight into the printer.

    Standard paper feed tray illustration

    To avoid paper jams, make sure the tray is securely inserted.

Note

Reference