Skip header
 

Setting Paper on the Bypass Tray

You can load paper that is not supported in the paper trays. Additionally, you can print on paper such as thick paper and OHP transparency by using the bypass tray.

Important

  • Paper sizes that can be loaded onto the bypass tray can be 70.0 to 216.0 mm (2.76 to 8.50 in.) vertically, and 127.0 to 600.0 mm (5.00 to 23.62 in.) horizontally.

  • The machine can automatically detect the following sizes as regular size paper:

    • region-a(mainly Europe and Asia)

      A4Landscape, A5Landscape, A6Landscape

    • region-b(mainly North America)

      81/2 multiplication 11Landscape, 71/4 multiplication 101/2Landscape, 51/2 multiplication 81/2Landscape

  • If you want to use the size of paper other than the above, be sure to specify the size.

  • The following functions are disabled when printing from the bypass tray:

    • Auto Tray Select

    • Extended Auto Tray Switching

    • Staple (types 2 and 4 only)

  • Certain types of OHP transparencies for color printing cannot be used.

  • For details about types of paper that can be used, contact your sales or service representative.

1Open the bypass tray.

Bypass tray illustration

2Insert the paper face down until you hear the beep, and then align the paper guides to the paper size.

If the guides are not flush against the paper, images might be skewed or paper misfeeds might occur.

Bypass tray illustration numbered callout illustration

  1. Paper Guide

  2. Extender

3Set the paper size using the printer driver or the control panel.

Note

  • Certain types of paper might not be detected properly when placed on the bypass tray. If this happens, remove the paper and place it on the bypass tray again.

  • Do not load paper over the limit mark in the bypass tray. Overloading the bypass tray can result in misfeeds and skewed images.

  • To support A4Landscape, 81/2 multiplication 11Landscape or larger paper sizes, pull out the extender.

  • To prevent multiple sheets from being fed at once, fan paper before placing it on the tray.

  • When loading thick paper, thin paper or OHP transparencies, set paper size and paper type.

  • The number of sheets that can be loaded in the bypass tray depends on the paper type.

  • When loading letterhead paper, see "Loading Paper", About This Machine.

  • Depending on the environment where the machine is being used, you might at times hear a rustling noise from paper moving through the machine. This noise does not indicate a malfunction.

  • When [Panel Key Sound] is turned off, it will not sound if you insert paper into the bypass tray. For details about [Panel Key Sound], see "System Settings", Network and System Settings Reference.

  • For details about setting printer drivers, see the printer driver Help.