ManualsContentsPreviousNext |
This section describes how to change the paper size in the small size paper tray.
If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side fences may slip out of place.
Check the paper edges are aligned at the right side.
Slide the side fences until they are aligned with the paper size, and then re-lock the side fences.
Various sizes of paper can be loaded in the small size paper tray by adjusting the positions of the side fences and end fence.
Check that paper in the small size paper tray is not being used, and then pull the tray carefully out until it stops.
Remove paper if loaded.
Release the lock on the side fences.
While pressing down the release lever, slide the side fences outward.
Slide the end fence outward.
Pinch the release levers of the end fence.
Slide the end fence outward.
Square the paper and load it print side up.
Do not stack paper over the limit mark.
Align the back and side fences gently against the paper you loaded.
Re-lock the side fences.
Carefully slide the small size paper tray fully in.
The small size paper tray cannot detect the paper size automatically. When changing the paper size, specify it with the control panel. For details, see “Changing to a Size That Is Not Automatically Detected”.
You can load envelopes in the small size paper tray. Be sure to close their flaps and set them in the orientation.
If you are copying onto 37/8 × 71/2, C6 Env, or DL Env envelopes and they become creased, set them in the orientation.
For details about various details about and recommendations concerning envelopes, see “Envelopes”.
For details about how to install the small size paper tray, see “Installing the Small Size Paper Tray”.