Skip header
ManualsContentsPreviousNextHelp

Setting Paper on the Bypass Tray

This section gives instructions for setting paper on the bypass tray.

For details about supported paper sizes and types, see "Recommended Paper Sizes and Types", About This Machine.

Important

  1. Set the paper size using the printer driver or control panel.

    Under [Printer Features], [System], if you set [Tray Setting Priority] to [Driver / Command], use the printer driver to specify the paper size.

  2. Adjust the bypass tray's paper guides to the size of the paper.

    If the paper size of the paper guide and the paper do not match, skewing and misfeeds might occur.

    Bypass tray illustration

  3. Send the print job to the machine.

  4. Gently push the paper face up into the bypass tray until the beeper sounds.

    Place the paper centrally, so that the space on either side of its edges is even.

    Then push it carefully in, so that it makes light contact with the feed rollers.

    Support the paper with your hands until it feeds in.

    The paper feeds into the machine automatically and printing starts.

    Bypass tray illustration

  5. Check that the paper is properly fed.

Note

Related topics

Setting the Paper Size Using the Control Panel
Setting Custom Size Paper Using the Control Panel
Setting Translucent Paper or Film Using the Control Panel