Changing the Paper Size in Trays 2 and 3
This section describes how to change the paper size in Trays 2 and 3.
If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side fences may slip out of place.
Check the paper edges are aligned at the right side.
Slide the side fences until they are aligned with the paper size, and then re-lock the side fences.
Various sizes of paper can be loaded in Trays 2 and 3 by adjusting the positions of the side fences and end fence.
Check that paper in the paper tray is not being used, and then pull the tray carefully out until it stops.
Remove paper if loaded.
Release the lock on the side fences.
While pressing down the release lever, slide the side fences until they are aligned with the paper size you want to load.
Make sure there are no gaps between the paper and side fences.
Slide the end fence until it is aligned with the size of paper you want to load.
Make sure there are no gaps between the paper and end fence.
Pinch the release levers of the end fence.
Slide the end fence until it is aligned with the paper size you want to load.
When adjusting the paper tray for custom size paper, pull up on the end fence to secure it at the required position.
Square the paper and load it print side down.
Do not stack paper over the limit mark.
Re-lock the side fences again.
Carefully slide the paper tray fully in.
Check the paper size on the display.
If you load a paper size that is not selected automatically, you will need to specify the paper size with the control panel. For details, see “Changing to a Size That Is Not Automatically Detected”.
If you want to load custom size paper, contact your service representative.
