Manuals
Contents
Previous
Next
| | | |
| |||
| |||
| | | |
| ManualsContentsPreviousNext | | |
This section describes how to load paper in the Wide Large Capacity Tray. The Wide Large Capacity Tray is referred to as Tray 3, Tray 4, Tray 5 and Tray 6.
Up to two Wide Large Capacity Trays can be installed.
To install two Wide Large Capacity Trays, the bridge unit is required.
Various regular sizes of paper can be loaded in the Wide Large Capacity Tray by adjusting the positions of side fences and end fence.
Check that the paper edges are aligned with the left side.
The tray can hold up to about 2,000 sheets of paper. Do not stack paper over the limit mark.
Carefully pull out the paper tray until it stops.
1. Paper transfer unit
Do not open the paper transfer unit when the paper tray is in use, or a misfeed might occur.
Release the end fence.
Load paper into the paper tray by pushing the paper to the left side of the paper tray.
Place paper with printing side up.
Set the end fence.
Carefully slide the paper tray fully in.
When paper is loaded which cannot be detected automatically, the user must set the paper size on the control panel.
 |
 | Copyright (C) 2008, 2009 |
