Skip headerPro 907/Pro 1107/Pro 1357
ManualsContentsPreviousNextHelp

Connecting to the IEEE 1284 Interface

This section describes how to connect the IEEE 1284 interface cable to the IEEE 1284 interface board.

CAUTION


  • For users outside the United States of America: properly shielded and grounded cables and connectors must be used for connections to a host computer (and/or peripheral) in order to meet emission limits.

  • For users in the United States of America: properly shielded and grounded cables and connectors must be used for connections to a host computer (and/or peripheral) in order to meet FCC emission limits.

  1. Make sure the main power is switched off.

  2. Turn off the main power switch of the host computer.

  3. Connect the IEEE 1284 interface cable to the IEEE 1284 port.

    Illustration of connecting the IEEE 1284 interface cable

    You might have to use a conversion adapter to connect the cable to the interface. For details about acquiring a conversion adapter, consult your sales or service representative.

  4. Connect the other end of the cable into the interface connector on the host computer.

    Check the shape of the connector to the computer. Connect the cable firmly.

  5. Turn on the main power switch of the printer.

  6. Turn on the host computer.

    A printer driver installation screen might appear when the computer is turned on. If this happens, click [Cancel] on the screen.

Note

Reference