ManualsContentsPreviousNext |
This section describes how to connect Ethernet interface cable to the Ethernet interface.
If the main power switch is on, turn it off.
Use the following Ethernet cables.
Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more
Make sure the main power is switched off.
Connect the 100BASE-TX/10BASE-T cable to the Ethernet port.
Connect the other end of the Ethernet interface cable to a network connection device such as a hub.
Turn on the main power switch of the printer.
Indicator (yellow)
Lights up yellow when 100 BASE-TX is in operation. Goes off when 10 BASE-T is in operation.
Indicator (green)
Lights up green when 10 BASE-T is in operation. Goes off when 100 BASE-T is in operation.
For details about how to turn on the main power switch, see "Turning On the Main Power", About This Machine.
For details about installing the printer driver, see "Installing the Printer Driver".