



	Manuals Contents Previous Next

Top Page > Hardware Guide > Configuration > Ethernet Configuration

Ethernet Configuration

Configure the following network settings according to the network interface you are using.

You can use SmartDeviceMonitor for Admin or a Web browser to configure IP address-related settings in a TCP/IP-capable environment.

Configure the printer for the network using the control panel.
The following table shows the control panel settings and their default values. These items appear in the [Host Interface] menu.

Setting Name	Value
IPv4 Settings	DHCP: On IPv4 Address: 11.22.33.44 Subnet Mask: 0.0.0.0 Gateway Address: 0.0.0.0
IPv6 Settings	Stateless Sett.: Active
IPsec	Not Active
Frame Type (NW)	Auto Select
Active Protocol	IPv4: Active IPv6: Not Active NetWare: Active SMB: Active AppleTalk: Active
Ethernet Speed	Auto Select
IEEE802.1X Auth	Not Active
LAN Type	Ethernet

If DHCP is in use on your network, the IP address, subnet mask, and gateway address are all set automatically.
The menu items displayed on the control panel may differ depending on the optional unit installed.
Make this setting only when it is necessary. See Software Guide.

Related topics

Specifying an IP Address (No DHCP)
Receiving an IP Address Automatically (DHCP)
Configuring Network Settings When Using NetWare
Setting the Ethernet Speed
Enabling IEEE 802.1X Authentication