Setting the Ethernet Speed

You can set the speed that the printer will use for Ethernet communications. In most cases, this should be left on the default setting, [Auto Select]. This setting allows two interfaces to automatically determine the optimum speed when they are connected.

Router/HUB	Printer
Router/HUB	10Mbps Half D.	10Mbps Full D.	100Mbps Half D.	100Mbps Full D.	Auto Select
10 Mbps half duplex		-	-	-
10 Mbps full duplex	-		-	-	-
100 Mbps half duplex	-	-		-
100 Mbps full duplex	-	-	-		-
auto-negotiation (auto selection)		-		-

Connection cannot be established if the selected Ethernet speed does not match your network's transmission speed.
The auto-negotiation mechanism allows two interfaces to automatically determine an optimum Ethernet speed as soon as they are connected. We recommend you select [Auto Select].

Press the [Menu] key.
The [Menu] screen appears.
Press the [] or [] key to display [Host Interface], and then press the [ Enter] key.
Press the [] or [] key to display [Network Setup], and then press the [ Enter] key.
Press the [] or [] key to display [Ethernet Speed], and then press the [ Enter] key.
Press the [] or [] key to select the Ethernet speed, and then press the [ Enter] key.
Press the [Menu] key.
The initial screen appears.
Print a configuration page to confirm the settings made.

If Ethernet and wireless LAN are both connected, select which interface you want to use under [LAN Type].
For details about printing the configuration page, see "Printing the Test Page", Quick Installation Guide.

"Printing the Test Page", Quick Installation Guide.