Unpacking

To protect it from shock and vibration during transit, this machine comes packaged in cushioning foam and secured with tape. Remove these protective materials after bringing the machine to where it will be installed.

Do not incinerate used toner or toner containers. Toner dust might ignite when exposed to an open flame. Dispose of used toner containers in accordance with local regulations.
Do not store toner, used toner, or toner containers in a place with an open flame. The toner might ignite and cause burns of a fire.

Keep toner (used or unused) and toner containers out of reach of children.
If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air environment. Consult a doctor if necessary.
If toner or used toner gets into your eyes, flush immediately with large amounts of water. Consult a doctor if necessary.
If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult a doctor if necessary.
When moving the machine, use the inset grips on both sides. The machine will break or cause injury if dropped.

Removed tape is dirty. Be careful not to let it touch your hands or clothes.
Leave the protective materials in place while moving the machine.
Lower the machine slowly and carefully to prevent trapping your hands.
Do not grip on the tray area when lifting the machine.
Do not allow paper clips, staples, or other small objects to fall inside the machine.
Keep uncovered print cartridges away from direct sunlight.
Do not touch the print cartridge's photo conductor unit.

Remove the plastic bag.
Lift the machine with another person by using the inset grips on both sides of the machine.
Remove the protective materials attached on the machine's exterior. Do not remove tapes going into the inside of the machine.
The actual machine may come with protective materials attached in different positions. Make sure to check the machine's exterior for all protective materials, and remove them completely.
Open the ADF cover.
Gently pull the protective sheet to remove it.
Close the ADF cover.
Pull the opening lever on the front cover, and then carefully lower the front cover.
Lower the blue fusing unit levers.
Holding each orange tape near its joint, pull both tapes gently upward and remove them from the machine at the same time.
Using both hands, carefully push up the front cover until it closes.
Pull up the top cover open lever, and then open the top cover carefully.
Make sure that the exposure glass cover or ADF is closed.
Remove the protection tape.
Lift out a print cartridge and shake it from side to side five or six times.
For the black print cartridge, remove the protection sheet.
Check the toner color and corresponding location, and then carefully insert the print cartridge vertically.
Repeat steps 13. and 14. for all print cartridges.
Using both hands, hold the center of the top cover and close the cover carefully. Be careful not to trap your fingers.