Skip headerimage
ContentsPreviousNextHelp

Top Page > Getting Started > Installing the Machine > Where to Put the Machine

Where to Put the Machine

The machine's location should be carefully chosen because environmental conditions greatly affect its performance.

WARNING

  • The supplied power cord is for use with this equipment only. Do not use with other appliances. Doing so may result in fire, electric shock, or injury.

  • Keep the machine away from flammable liquids, gases, and aerosols. A fire or an electric shock might occur.

  • The wall outlet shall be installed near the machine and shall be easily accessible.

  • Connect the machine only to the power source described on the inside front cover of this manual. Connect the power cord directly into a wall outlet and do not use an extension cord. Do not damage, break or make any modifications to the power cord. Do not place heavy objects on it. Do not pull it hard nor bend it more than necessary. These actions could cause an electric shock or fire.

CAUTION

  • Keep the machine away from humidity and dust. Otherwise a fire or an electric shock might occur. Do not place the machine on an unstable or tilted surface. If it topples over, an injury might occur.

  • Keep the machine in an area that is within optimum environmental conditions. Operating the machine in an environment that is outside the recommended ranges of humidity and temperature can cause an electrical fire hazard. Keep the area around the socket free of dust. Accumulated dust can become an electrical fire hazard.

  • Make sure the room where you are using the machine is well ventilated and spacious. Good ventilation is especially important when the machine is used heavily.

Space Required for Installation

The recommended (minimum) space requirements are as follows:

image

Optimum Environmental Conditions

Place the machine at the floor with elevation of less than 3mm in forward/back and left/right direction.

Permissible and recommended temperature and humidity ranges are as follows:

image

  • White area: Permissible Range

  • Gray area: Recommended Range

Note

  • To avoid build up of ozone, be sure to locate this machine in a large, well ventilated room that has an air turnover of more than 30 m3/hr/person.

  • When you use this machine for a long time in a confined space without good ventilation, you may detect an odd smell. To keep the workplace comfortable, we recommend that you keep it well ventilated.

Environments to Avoid

Important

  • Areas exposed to direct sunlight or strong light

  • Dusty areas

  • Areas with corrosive gases

  • Areas that are excessively cold, hot, or humid

  • Locations near air conditioners or humidifiers

  • Locations near other electronic equipment

  • Locations subject to frequent strong vibration

Power Source

Connect the power cord to a power source of the following specification:

  • image: 120 V, 50/ 60 Hz, 11 A or more (when fully equipped)

  • image: 220-240 V, 50/ 60 Hz, 6 A or more (when fully equipped)

TopPreviousNext
Copyright (C) 2008