ManualsContentsPreviousNext |
Replace all feed rollers including the printer and the optional paper feed unit(s). The following procedure shows how to replace the printer's paper feed rollers.
The printer weights approximately 50 kg (110 lb.). When moving the printer, use the inset grips on both sides, and lift slowly. The printer will break or cause injury if dropped.
Lifting the paper feed unit carelessly or dropping it may cause injury.
Make sure the printer is lifted by at least four people.
Always move the printer horizontally. Turning the printer sideways or tilting it backward or forward while moving will result in toner leakage.
Do not put the printer on an unstable or sloped surface.
Move the printer to the edge of a sturdy and stable table or desk.
If the printer is equipped with the optional paper feed unit, do not move the printer and the unit together, they are not securely attached.
Slide the green lock lever to the right (), remove the paper feed roller ().
The illustration shows the paper feed roller installed in the printer.
While sliding the green lock lever to the right (), set the new roller ().Then, return the green lock lever to its original position ().
Check the green lock lever secures the roller correctly by making sure the new roller rotates smoothly.
If the printer has the optional paper feed unit(s) installed, follow the same procedure or remove only the additional tray to replace the paper feed roller.
If you have two paper feed units installed, also replace both paper feed rollers.
Place paper in the paper trays and additional removed paper trays. Lift the front of the tray, and slide it carefully into the printer, until it stops.